
Commands by Subsystem 5
Agilent InfiniiVision 6000 Series Oscilloscopes Programmer's Guide 215
:BUS<n>:CLEar
(see page 798)
Command Syntax
:BUS<n>:CLEar
<n> ::= An integer, 1 or 2, is attached as a suffix to BUS
and defines the bus that is affected by the command.
The :BUS<n>:CLEar command excludes all of the digital channels from the
selected bus definition.
See Also • "Introduction to :BUS<n> Commands" on page 211
• ":BUS<n>:BIT<m>" on page 212
• ":BUS<n>:BITS" on page 213
• ":BUS<n>:DISPlay" on page 216
• ":BUS<n>:LABel" on page 217
• ":BUS<n>:MASK" on page 218
This command is only valid for the MSO models.
Kommentare zu diesen Handbüchern