Agilent Technologies 1100 Series Bedienungsanleitung PDF herunterladen (Seite 21)

Installing your System

Installing the Manual Injector and 1100 series HPLC modules

Installing the Manual Injector and 1100

series HPLC modules

NOTE Assure that all power switches on the 1100 HPLC modules are in OFF (out)

position.

NOTE The manual injector can be installed at the left- or right-hand side of the

instrument stack.

1 Place the base plate on the bench.

2 Screw the mounting pole into one of the three holes in the base plate.

3 Ensure the two plugs are positioned at the rear of the base plate. If required,

remove the plugs, and insert them in the correct position (see Figure 3).

Figure 3 Installing the Mounting Pole

4 Slide the manual injector onto the mounting pole (see Figure 6). Tighten the

mounting screw.

Insert plugs at rear

position

Insert plugs at rear

position

If installed, remove plugs

from front position

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 75 76

Keine Kommentare

Agilent Technologies 1100 Series Bedienungsanleitung Seite 21