Agilent Technologies 1100 Series Installationsanleitung PDF herunterladen (Seite 6)

1100 LC Modules Control Manual - 6 - 03-914947-30:Rev.6

NOTE: For more details about the configuration of a GPIB_Interface or an NI488 bus,

refer to the Galaxie Chromatography Data System Installation Guide.

Connecting the Agilent LC 1100 modules to Galaxie

The Galaxie Chromatography Data System uses GPIB to

communicate with the Agilent 1100 modules.

For each Agilent 1100 module controlled by Galaxie, a switch

located on the rear panel of the instrument must be configured

appropriately. For all the modules, the first three switches from

left must be turned off (Down Position) for control with Galaxie as

for control with HP-CHEMSTATION. Changing the position of

these switches must be done with module switched-off.

1 2 3 4 5 6 7 8

The module where the GPIB cable is connected should be the

detector of the HPLC chain (as recommended by Agilent). This

module is called the Master module. The rest of the modules of

the HPLC chain communicate through the Master module via

CAN cables. The GPIB address entered in each module in the

Galaxie Configuration Manager must be the GPIB address of the

master module.

Up (on)

Down (off)

1 2 3 4 5 6 7 8 9 10 11 ... 183 184

Keine Kommentare

Agilent Technologies 1100 Series Installationsanleitung Seite 6