Agilent Technologies PSG Bedienerhandbuch PDF herunterladen (Seite 132)

Programming the Status Register System

Status Groups

Chapter 3118

Standard Operation Condition Register

The Standard Operation Condition Register continuously monitors the hardware and

firmware status of the signal generator. Condition registers are read only.

Table 3-5 Standard Operation Condition Register Bits

Bit Description

0 Unused. This bit is always set to 0.

1 Settling. A 1 in this bit position indicates that the signal generator is settling.

2 Unused. These bits are always set to 0.

3 Sweeping. A 1 in this bit position indicates that a sweep is in progress.

4 Unused. This bit is always set to 0.

5 Waiting for Trigger. A 1 in this bit position indicates that the source is in a “wait for

trigger” state of the trigger model.

6,7,8 Unused. These bits are always set to 0.

DCFM/DCφM Null in Progress. A 1 in this bit position indicates that the signal

generator is currently performing a DCFM/DCΦM zero calibration.

10 Unused. This bit is always set to 0.

11 Sweep Calculating. A 1 in this bit position indicates that the signal generator is

currently doing the necessary pre-sweep calculations.

12, 13, 14, Unused. These bits are always set to 0.

15 Always 0.

Query:

STATus:OPERation:CONDition?

Response: The decimal sum of the bits set to 1

Example: The decimal value 520 is returned. The decimal sum = 512 (bit 9) + 8 (bit 3).

1 2 ... 127 128 129 130 131 132 133 134 135 136 137 ... 361 362

Keine Kommentare

Agilent Technologies PSG Bedienerhandbuch Seite 132