Agilent Technologies E6640A EXM Wartungshandbuch PDF herunterladen (Seite 126)

126 Chapter 9

Sequence Setup Commands

Programming Analyzer Sequences (Parameter-Specific Commands)

Sequence Setup Commands

Analysis Step Parameters (Parameter-Specific Commands)

Each of these commands can be used to change just one parameter of an analysis step within an

acquisition.

1: Analysis Number

As analysis steps are simply numbered sequentially within the acquisition, there is no parameter-specific

command for setting the number of an analysis step. However, in the commands given below, it is

necessary to identify the analysis interval by number in the ASTep value.

2: Analysis Offset

For a description of this parameter, see “2: Analysis Offset” on page 31. The parameter-specific

commands are described below.

SCPI Command

To set the analysis offset as an individual value:

[:SENSe]:LSEQuencer:ACQuire{1:512}:ASTep{1:1000}:SETup:

TIME:OFFSet <time>

[:SENSe]:LSEQuencer:ACQuire{1:512}:ASTep{1:1000}:SETup:

TIME:OFFSet?

To set the analysis offset as an array:

[:SENSe]:LSEQuencer:ACQuire{1:512}:LIST:SETup:TIME:

OFFSet <time>,<time>,<time>,…

[:SENSe]:LSEQuencer:ACQuire{1:512}:LIST:SETup:TIME:

OFFSet?

The array form of the command is used to make a different setting for each

analysis interval in the acquisition (the number of array values must match the

number of analysis intervals; otherwise a "settings conflict" error will occur).

SCPI Examples :LSEQ:ACQ2:AST3:SET:TIME:OFFS 10ms

:LSEQ:ACQ2:AST3:SET:TIME:OFFS?

:LSEQ:ACQ2:LIST:SET:TIME:OFFS 500us,1ms,2ms

:LSEQ:ACQ2:LIST:SET:TIME:OFFS?

1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 339 340

Keine Kommentare

Agilent Technologies E6640A EXM Wartungshandbuch Seite 126