Agilent Technologies 6002A Betriebsanweisung PDF herunterladen (Seite 268)

D Single-Mode/Multimode Module Performance TestsOptional Test VI: E6007A Visual Fault Finder

268 E6000C Mini-OTDR User’s Guide, E0302

Set up DUT 5 On the DUT, select Visual Fault Finder:

and allow to settle.

Note result in test record 6 Note the displayed power level on the Multimeter in the

test report.

Optional test: Center Wavelength

NOTE The laser has been vendor tested, and specifications are

purely typical. Therefore, this test is not mandatory.

Connect equipment 1 Connect the E6007A output to the Optical Spectrum

Analyzer using an 81101A patchcord, and two 81000AI

interface adapters:

– ensure that the OSA is switched on and has warmed

up.

– ensure that the E6000C is switched on and has

warmed up.

– enable the E6007A (DUT).

Set up OSA 2 On the Optical Spectrum Analyzer:

– press I

NSTRPRESET

– press AUTO/MEAS and wait until End of

Automeasure is displayed.

– choose U

SER and then select the type of source to be

measured as FP (for Fabry-Perot Laser).

To show the display in linear mode:

– press M

ENU

– select AMPT on the left side of the display

Select Mod CW

Select ON

1 2 ... 263 264 265 266 267 268 269 270 271 272 273 ... 319 320

Keine Kommentare

Agilent Technologies 6002A Betriebsanweisung Seite 268