Agilent Technologies 8000 Series Spezifikationen PDF herunterladen (Seite 106)

Chapter 6: Replacing Assemblies

To remove and replace the internal digital input cable (MSO models only)

106

To remove and replace the internal digital input cable (MSO models

only)

Use this procedure to remove and replace the internal digital cable. When necessary, refer to

other removal procedures. The graphics in this chapter are representative of the oscilloscope at

the time of this printing. Your unit may look different.

Disconnect the power cable and remove the bottom sleeve.

2 Remove the AutoProbe board assembly from the front frame (see page 104).

3 Use a small screwdriver to remove the spring clip from the internal digital cable

connector then disconnect the cable from the acquisition board.

4 Clip the tie wraps holding the digital cable and shield to the side of the chassis.

5 Using a Torx T10 driver remove the screw holding the internal digital cable to the front

panel.

Figure 6-11

Removing the internal digital cable

6 Pull the internal digital cable out through the rear of the front panel.

7 To replace the internal digital cable, reverse the above procedure.

Shield

T10 torx

Internal

digital

cable

Acquisition

board

Tie wrap

Spring clip

Tie wrap

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 161 162

Keine Kommentare

Agilent Technologies 8000 Series Spezifikationen Seite 106