Agilent Technologies 6634A Bedienungsanleitung PDF herunterladen (Seite 44)

Connecting the DUT Power Supply Cables

Connecting the DUT

Power Supply

Cables

This section contains:

■ Introduction, 41

■ Connecting the Output Cables, 41

■ Connecting the Overvoltage Shutdown Cables, 59

■ Connecting the Power and GPIB Cables, 69

■ Connecting Output, Overvoltage, Power and GPIB

Cables in the 79000, 74

Introduction

You install four types of cables with the DUT power

supply: the output cable, overvoltage cable, power cord,

and GPIB cable. These sections describe how to connect

each of these cables, as well as how to program the

GPIB address in the DUT power supply.

The 79000 system has the cables for two 6634A/Bs and

one 6624A installed in the testhead in the factory. The

cable connections for the output cables, over voltage

cables and GPIB cables are shown in

Connecting

Output, Overvoltage, Power and GPIB Cables in the

79000 on page 74.

Connecting the Output Cables

This section describes how to connect the output cables

for the DUT power supplies. These instructions are for a

system being configured for the first time.

Table 8

shows the various models of programmable DUT power

supplies available.

NOTE

When adding a supply, the configuration of

existing supplies may prevent you from following

all of these procedures. Do not reconfigure

existing supplies. Reconfiguring existing supplies

is likely to cause previously developed board tests

to fail.

Table 8 DUT power supplies

Product No. Model No. Description

44940A

E3785A

6624A 4 outputs: 2 @ 0-7 V, 0-5 A or 0-20 V,

0-2 A and

2 @ 0-20 V, 0-2 A or 0-50 V, 0-0.8 A

44941A 6621A 2 outputs: 0-7 V, 0-10 A or 0-20 V, 0-4 A

E4034A 6634A/B

1output: 1-100 V, 0-1 A

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 81 82

Kommentare zu diesen Handbüchern

Keine Kommentare

Agilent Technologies 6634A Bedienungsanleitung Seite 44

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Synthesizer Agilent Technologies 6634A