Agilent Technologies 6634A Bedienungsanleitung PDF herunterladen (Seite 35)

Installing DUT Power Supplies

3 Determine whether the radiation shield

(E3770-00601) is installed in the bottom DUT power

supply slot.

Figure 11 on page 31 shows the location

of the radiation shield. If the shield is not in place,

you must remove the power supply in the bottom slot

(if one is present) and install the shield, as described

in the next step; if the shield is in place, skip the next

step.

4 To install the radiation shield, remove all wires and

the power cord from the rear of the 6624A or 6621A

power supply, noting where they were connected.

Remove the power supply from the front of the

testhead. Install the radiation shield as shown in

Figure 12 on page 33, and fasten with the four

screws provided using a #2 Pozidriv screwdriver.

Reinstall the power supply. Reconnect the wires and

power cord to the power supply.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 81 82

Keine Kommentare

Agilent Technologies 6634A Bedienungsanleitung Seite 35