Agilent Technologies J3916A Bedienungsanleitung PDF herunterladen (Seite 114)

Probe Operation

Restarting the Probe

Selecting the Warm Start Menu Item

Use the following procedure to warm start the probe using the probe’s Main

Menu:

1. Connect a local terminal (or a PC emulating a terminal) to the probe. Refer

to “Local Terminal Configuration and Installation” on page 4 for

information on connecting a local terminal.

2. Press the CONFIG button once (on the back of the probe) to place the probe

into the configuration mode. Use a narrow, pointed object (like a pen) to

press the recessed CONFIG button. The probe then displays its Main Menu

on the terminal. Figure 5-1 shows the probe’s Main Menu.

3. Press

to execute a warm start and exit the probe’s Main Menu. The warm

start occurs immediately. The Activity and Fault LEDs are turned on during

a warm start. When the warm start completes, the Activity LED flashes to

indicate traffic (if present), the Fault LED turns off, and the ~Line On (or

Power) LED is on.

Main Menu - Revision

1.Modify/View configuration values ->

2.Modify/View security values ->

3.Modify/View interface values ->

4.Display interface summary

5.TFTP Download new firmware ->

6.XMODEM Download new firmware ->

7.Warm start and Exit

8.Cold start and Exit

Figure 5-1: Probe Main Menu

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 178 179

Keine Kommentare

Agilent Technologies J3916A Bedienungsanleitung Seite 114