Agilent Technologies ENA Series Betriebsanweisung PDF herunterladen (Seite 5)

Installation of TRL/LRM Calibration VBA Macro

NOTE

Before installing this VBA macro, make sure that your E5070B/E5071B’s firmware revision is 3.5 or above.

Installation Procedure

1) Prepare the floppy disk that contains the installation program, “E507X_TRL_LRM_CAL_100.msi”.

2) Reboot the ENA (Turn the ENA’s power OFF, and then turn it ON again).

3) Insert the floppy disk in the ENA.

4) Press [Save/Recall], Explorer to open the Windows Explorer and double-click on the installation

program in the A drive.

5) Install the TRL/LRM Calibration VBA Macro by following the instructions of the installation program.

6) The TRL/LRM Calibration VBA Macro program “TRL_LRM_cal.vba” will be installed under the path

D:/VBA.

1 2 3 4 5 6 7 8 9 10 11 12 13

Keine Kommentare

Agilent Technologies ENA Series Betriebsanweisung Seite 5