Agilent Technologies U4154A Installationsanleitung PDF herunterladen (Seite 20)

20 U4154A Logic Analyzer Installation Guide

2 Setting up the Hardware for U4154A

Step 2 - Install the U4154A Module in the AXIe Chassis

The AXIe chassis and U4154A module come in separate

shipments. The module is not pre- installed in the chassis.

This step involves carefully inserting the U4154A module in

an empty slot of an Agilent AXIe chassis. The slots are

identified by the slot numbers written on the front panel of

the chassis.

To insert the U4154A module into the chassis

1 Locate the module insertion/extraction handles at both

ends of the U4154A module. Extend the ends of both

handles, by pulling them inwards towards each other.

Then fully open the handles by pivoting them out towards

you.

2 Align the module’s PCA board with the guide rails on

both ends of the AXIe chassis. If the module has metal

plates covering the board, be sure to insert the PCA

board and not the metal plates into the rails.

3 Push the U4154A module into the slot of the chassis until

the module insertion/extraction handles are pressed up

against the chassis. Nudge the module gently to allow the

handles to engage.

4 Using your thumbs, press inwards firmly until the module

is seated firmly in the chassis backplane. The module’s

front panel should lie flush with the chassis front panel.

5 Push the handles ends towards the edge of the chassis to

tuck them away.

CAUTION

- The U4154A module is not hot swappable: You must power down

the AXIe chassis and host PC before inserting, replacing, or

removing the module.

- The enclosure surface of the U4154A module may become hot

during use. If you need to remove the module, first power down the

AXIe chassis, allow the module to cool, and then pull the module out

of the chassis.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 67 68

Keine Kommentare

Agilent Technologies U4154A Installationsanleitung Seite 20