Agilent Technologies 54657A Betriebsanweisung PDF herunterladen (Seite 51)

To edit an individual pixel of a mask

Previously created masks can be edited pixel-by-pixel using the line drawing

editing tool. The Delay knob selects the column to be edited, and the

Cursors knob moves the mask vertically.

Press

± .

2 Press the Mask Test softkey.

3 Press the Use Mask softkey to select the desired mask number (1 or 2).

4 Press the Define Mask Editor softkey.

5 Toggle the Edit Line softkey to select the limit line that you want to

edit.

6 Turn the Delay knob to move the cursor to the pixel (column) that

you want to modify.

7 Turn the knob closest to the Cursors key to edit the vertical

position of the pixel.

It is possible to repeat steps 6 and 7 (simultaneously) using two hands to

create a nice smooth mask.

Pixel Editing Operating Hint

The time and voltage shown at the bottom of the screen corresponds to the

current time base and vertical setting of lowest number of all active channels. If

the mask is voltage and time dependent, make sure that the current time base

and vertical setting are the same as the one that you are going to use during the

actual testing.

Once the Cursor knob is moved, the selected pixel is edited. To remove

undesired edits, use the mark and connect softkeys (previously discussed).

Operating the Measurement/Storage Module

To edit an individual pixel of a mask

2–35

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 88 89

Keine Kommentare

Agilent Technologies 54657A Betriebsanweisung Seite 51