Agilent Technologies 8935 Series Spezifikationen PDF herunterladen (Seite 194)

Chapter 8 193

Performance Tests

RF Generator Level Accuracy Performance Test 5

7. On the signal generator set the level to +8 dBm or whatever level is

suitable for the microwave converter’s LO input.

8. For frequencies of 1700 and 2000 MHz perform the following:

a. On the signal generator set the frequency to 1900 MHz CW and

2200 MHz CW respectively.

b. Reset the measuring receiver.

c. On the measuring receiver set the frequency offset mode to enter

and enable the LO frequency (27.3 Special) then key in the signal

generator (LO) frequency (in MHz) which is 1900 or 2200 MHz

respectively.

d. On the measuring receiver set the measurement mode to tuned

RF level and the measurement units to dBm then press SET REF.

e. Measure and record the RF level at the levels down to and

including -80 dBm shown in the PTR at the Test Set's DUPLEX

OUT port. If the measuring receiver displays the need to

recalibrate, press the CALIBRATE key and wait for calibration to

be completed.

f. After recording the reading at -80 dBm insert an RF amplifier

into the output of the Test Set.

g. Record the new measured level at -80 dBm.

h. Continue measuring the level down to -125 dBm.

i. Move the input to the microwave converter to the RF IN/OUT

port without the amplifier inserted.

j. Measure and record the RF level at the levels down to and

including -80 dBm shown in the PTR at the Test Set's RF IN/OUT

port.

k. After recording the reading at -80 dBm insert an RF amplifier

into the output of the Test Set.

l. Record the new measured level at -80 dBm.

m.Continue measuring the level down to -125 dBm.

n. Correct the measured reading for each level measured without

the amplifier as follows: Add the RF power measured in step 3c or

5b to the measured level. (For example, if the level in step 3c is

-10.2 dBm and the level at -55 dBm is -45.1 dB, record a level of

-10.2 + (-45.1) = 55.3 dBm.) Compare the corrected values with

the limits in the PTR.

o. Correct the measured reading for each level measured with the

amplifier by summing the following values:

+ RF power measured at -10 dBm in step 3c or 5b

1 2 ... 189 190 191 192 193 194 195 196 197 198 199 ... 342 343

Keine Kommentare

Agilent Technologies 8935 Series Spezifikationen Seite 194