Agilent Technologies 86100D Bedienungsanleitung PDF herunterladen (Seite 9)

:HARDcopy

The entire :HARDcopy subsystem was changed to accommodate the MS-Windows

compatible printing system. All

:HARDcopy outputs can be fully configured using the new 86100A commands working on top of the MS-Windows operating

system. The following 83480A commands are not required:

:HARDcopy:ADDRess

:HARDcopy:BACKground

:HARDcopy:DESTination

:HARDcopy:DEVice

:HARDcopy:FFEed

:HARDcopy:FILename

:HARDcopy:LENGth

:HARDcopy:MEDia

:HISTogram

:HISTogram:RRATe not required. The 86100A optimizes the refresh rate internally.

:HISTogram:SCALe consolidated into :HISTogram:SIZE

:LTESt - Limit Test

:LTESt:SSCReen:DPRinter

:LTESt:SSUMmary:ADDRess;FORMat;MEDia;PFORmat;PORT;

:MARKer

:MARKer:CURSor?

:MARKer:MEASurement:READout - Use :MEASure:ANNotation

:MARKer:MODE

:MARKer:XUNits?

:MARKer:YUNits?

:MTESt - Mask Test

:MTESt:AMASk:Create - The AMASk subsystem is not currently supported.

:MTESt:AMASk:SOURce

:MTESt:AMASk:UNITs

:MTESt:AMASk:XDELta

:MTESt:AMASk:YDELta

:MTESt:AMODe - There is only one Mask Alignment mode - Align to waveform.

:MTESt:DEFine - Custom masks are not currently supported.

:MTESt:POLYgon:DEFine

:MTESt:RECall - Masks can be recalled from files on the internal hard disk.

:MTESt:SAVE - Saving masks is not currently supported.

:MTESt:STANdard - STANdard is no longer supporeted.

Windows is a U.S. registered trademark of Microsoft Corporation.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 21 22

Keine Kommentare

Agilent Technologies 86100D Bedienungsanleitung Seite 9