Agilent-technologies Wireless Network Optimization Platform E6474A Bedienungsanleitung PDF herunterladen (Seite 125)

Getting Assistance, If You Need It 6

Agilent E6474A User’s Guide 125

Setting an iDEN phone’s baud rate

The baud rate for any iDEN phone must be set to 19200

baud, otherwise the phone may not be identified (this

applies to serial connections only). The following is the

procedure for the i1000 Plus phone.

1 Power up the phone. Wait for “Phone Ready” to be

displayed.

2 Press the Menu key 3 times.

3 Press the key under Prgm shown in the display. The

Programming Menu is displayed.

4 Press the key under OK in the display.

5 Press the right arrow key until Set Baud Rate: <value> is

displayed.

6 Press the key under OK in the display.

7 Press the right arrow key until 19200 is displayed.

8 Press the key under OK in the display.

9 Press the key under Exit in the display.

Toshiba phone power-up issues

Toshiba direct-connect phone power-up

Toshiba JCDMA phones have special power- up procedures.

Each time you power up the system, you must perform the

following procedure to enable communication between the

phone and the data collection software. Begin all of the

following procedures with the phone and computer powered

off.

Toshib a 1 0-CT

1 Unplug the phone interface cable from the phone.

2 Power the computer on.

3 Power the phone on.

4 Plug the interface cable into the phone.

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 193 194

Keine Kommentare

Agilent-technologies Wireless Network Optimization Platform E6474A Bedienungsanleitung Seite 125