Agilent Technologies 86100B Wartungshandbuch PDF herunterladen (Seite 13)

1-7

General Information

Cleaning Optical Connectors

To clean an adapter

1 Apply isopropyl alcohol to a clean foam swab.

Cotton swabs can be used as long as no cotton fibers remain after cleaning. The foam swabs listed

in this section’s introduction are small enough to fit into adapters.

Although foam swabs can leave filmy deposits, these deposits are very thin, and the risk of other

contamination buildup on the inside of adapters greatly outweighs the risk of contamination by

foam swabs.

2 Clean the adapter with the foam swab.

3 Dry the inside of the adapter with a clean, dry, foam swab.

4 Blow through the adapter using filtered, dry, compressed air.

Nitrogen gas or compressed dust remover can also be used. Do not shake, tip, or invert com-

pressed air canisters, because this releases particles in the can into the air. Refer to instructions

provided on the compressed air canister.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 165 166

Keine Kommentare

Agilent Technologies 86100B Wartungshandbuch Seite 13