Agilent Technologies Ininiium 9000 Betriebsanweisung PDF herunterladen (Seite 93)

Using the Oscilloscope

To set an edge trigger

3-57

To set an edge trigger

1 Click on the trigger setup button at the bottom of the waveform display.

This brings up the trigger configuration dialog. See “To access the trigger setup.”

2 Click on Edge.

3 Click on the source you want to use for the trigger signal.

4 Click to select the rising edge, falling edge, or both edges for the trigger source.

5 Set the trigger level using the spin box.

You can also click on the trigger level setting to display a pop-up numeric keypad,

where you can enter the trigger level directly.

Figure 3-27

Setting an Edge Trigger

Select rising edge,

falling edge, or both

Set the trigger

level using the spin

box controls

Select the trigger

source

Select Edge mode

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 111 112

Keine Kommentare

Agilent Technologies Ininiium 9000 Betriebsanweisung Seite 93