OmniBER 718Printed in U.K. 9/0037718-90220In This GuideInstructions on how to quicklyselect main instrument functions.Quick Reference Guide
8Selecting and Using Signal Features (cont’d)Setting up POS Transmitter IP Address [SDH/SONET] SETUP [IP ADDRESS] <SELECT> Setting up POS Tran
9Making MeasurementsUsing Overhead BER Test Function [SDH] TEST FUNCTION [SDH] [OVERHEAD BER]Test Timing RESULTS [TIMING CONTROL]Making SDH Analysis
10Making Measurements (cont’d)Performing an SDH Tributary Scan [SDH] TEST FUNCTION [TRIB SCAN] RESULTS [SDH TRIB SCAN]Performing an SDH Alarm Scan R
11Storing, Logging and PrintingSaving Graphics Results to Instrument Store [TIMING CONTROL] GRAPH STORAGE [1 MIN RESOL’N]Recalling Stored Graph Result
12Storing, Logging and Printing (cont’d)Logging Results to RS-232-C Printer FUNCTION [LOGGING] SETUP [DEVICE]LOGGING PORT [RS232]Logging Results Con
13Using Instrument and Disk StorageStoring Configurations in Instrument Store FUNCTION [STORED SETTINGS]Storing Current Configurations on Disk FUNCT
14Using Instrument and Disk Storage (cont’d)Recalling Graphics Results from Disk FUNCTION [FLOPPY DISK] DISK OPERATION [RECALL] FILE TYPE [GRAPHICS]Co
15Selecting and Using "Other" FeaturesCoupling Transmit & Receive Settings FUNCTION [SETTINGS CONTROL]TRANSMITTER AND RECEIVER [COUPLED]
16Selecting and Using "Other" Features (cont’d)Dumping Display to Disk FUNCTION [LOGGING] SETUP [DEMAND] LOG ON DEMAND [SCREEN DUMP]Setting
OmniBER 718Printed in U.K. 9/0037718-90220In This GuideInstructions on how to quicklyselect main instrument functions.Quick Reference Guide
frcover.fm Page 2 Thursday, September 7, 2000 1:43 PM
1IntroductionUse this book to quickly access the main instrument functions and tasks.Setting the InterfacesSetting the Transmit InterfacesSetting PDH
2Setting the Receive InterfacesUsing Smart Test [RUN TEST]Setting PDH Receive Interface [PDH/DSn] Setting SDH Receive Interface [SDH] Setting Jitter R
3Selecting Test FeaturesSelecting and Using Overhead FeaturesUsing Transmit Overhead Setup [SDH] Using Receive Overhead Monitor [SDH] Setting Overhead
4Selecting and Using Signal FeaturesAdding Frequency Offset to the SDH Signal [SDH] CLOCK [INTERNAL] FREQUENCY OFFSET [ON]Adding Frequency Offset to
5Selecting and Using Signal Features (cont’d)Inserting an External PDH Payload/Test Signal [SDH] 2M PAYLOAD [INSERT 2Mb/s] [PDH/DSn] 2M PAYLOAD [I
6Selecting and Using Signal Features (cont’d)Generating Automatic Protection Switch Messages [SDH] SETUP [APS MESSAGES]Inserting Data Communications
7Selecting and Using Signal Features (cont’d)Setting up ATM Errors and Alarms
Kommentare zu diesen Handbüchern